ISO 25178-73:2019

Abstract

This document defines classes of geometrical defects that might be present on the surfaces of material measures and calibration specimens conforming to ISO 5436-1 and ISO 25178-70, and defines terms for ways of responding to these defects.

This document is applicable as follows:

a) to help customers and users of material measures for surface metrology specify their nominal features (ideal geometrical properties) when obtaining them from manufacturers and suppliers;

b) to enable users of material measures to formulate their own rules and policies for responding to the occurrence of defects in such a way as to minimize the uncertainty of their own measurements;

NOTE Such policies are required in ISO/IEC 17025:2017, 7.2.1.1, 7.2.1.3, 7.3.1 and 7.8.5 c) and d), for example.

c) to enable calibration laboratories and their customers to agree on a common policy on how to treat defects on a material measure that has been sent for calibration;

d) to educate users of material measures about the different significance and importance of different kinds of defect;

e) for other GPS standards which make reference to the issue of selection of measuring locations, or selection of areas to be measured or avoided in measurement.

General information

Status
: Published

Publication date
: 2019-05
Edition
: 1

Number of pages
: 7
Technical Committee
: ISO/TC 213 Dimensional and geometrical product specifications and verification
ICS
:
01.040.17 Metrology and measurement. Physical phenomena (Vocabularies)

17.040.40 Geometrical Product Specification (GPS)