ISO 669:2016

Estado : Publicado (En proceso de revisión)

Esta norma se revisó y confirmó por última vez en 2021. Por lo tanto, esta versión es la actual.

	Formato	Idioma
std 1 173	PDF
std 2 173	Papel

Convertir Franco suizo (CHF) a tu moneda

Resumen

ISO 669:2016 defines and specifies certain identified electrical and mechanical characteristics of equipment used for

- resistance spot welding,

- projection welding,

- resistance seam welding,

- upset welding[1], and

? flash welding[2].

ISO 669:2016 specifies the information to be given in equipment specifications and the test methods to be used for measuring those characteristics.

Not all requirements apply to all types of equipment.

The following types of power sources are included:

- single phase with alternating welding current;

- single phase with rectified welding current by rectification of the output of the welding transformer;

- single phase with inverter welding transformer;

- three phase with rectified welding current by rectification of the output of the welding transformer;

- three phase with a current rectification in the input of the welding transformer (sometimes called frequency convertor);

- three phase with inverter welding transformers.

ISO 669:2016 Standard does not apply to welding transformers that are separate from the equipment.

NOTE Safety requirements for resistance welding equipment are covered by IEC 62135?1.

[1] Often referred to by the non-preferred term, butt welding.

[2] Often referred to by the non-preferred term, flash butt welding.

Previsualice esta norma en nuestra Plataforma de navegación en línea (OBP)

Check out our FAQs

Customer care

+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)