Draft
International Standard
ISO/DIS 6789-1
Assembly tools for screws and nuts — Hand torque tools — Part 1: Requirements and methods for design conformance testing and quality conformance testing: minimum requirements for declaration of conformance
Reference number
ISO/DIS 6789-1
Edition 2
© ISO 2025
Draft International Standard
Under development
This Draft International Standard is in the enquiry phase with ISO members.
Will replace ISO 6789-1:2017

Abstract

This document specifies the conformance testing and marking requirements for hand torque tools used for controlled tightening of screws and nuts. It also specifies the minimum requirements for a manufacturer’s declaration of conformance for hand torque tools.

This document applies to hand torque tools which are classified as indicating torque tools (Type I) and setting torque tools (Type II).

NOTE          Hand torque tools covered by this document are those identified in ISO 1703:2018 by reference numbers 7 1 00 01 0 to 7 1 00 14 0 inclusive.  Torque limiting hand torque tools do not yet have reference numbers and will not do so until the next revision of ISO 1703

This document does not specify requirements of calibration certificates for hand torque tools. These are described in ISO 6789‑2.

This document does not specify requirements for verifying the performance of hand torque tools. These are described in ISO 6789-3.

General information

Life cycle

Sustainable Development Goals

This standard contributes to the following Sustainable Development Goal

8
Decent Work and Economic Growth

Got a question?

Check out our Help and Support

  2. Store
  3. Store
  4. ICS
  5. 25
  6. 25.140
  7. 25.140.30
  8. ISO/DIS 6789-1