Тезис
PreviewThis document establishes the general principles and procedures to be followed when machining and notching test specimens from compression-moulded and injection-moulded plastics, extruded sheets, plates and partially finished or wholly finished products.
In order to establish a basis for reproducible machining and notching conditions, the following general standardized conditions are applied. It is assumed, however, that the exact procedures used are selected or specified by the relevant material specification or by the standards on the particular test methods. If sufficiently detailed procedures are not thus specified, the interested parties agree upon the conditions to be used.
-
Текущий статус: ОпубликованоДата публикации: 2018-12
-
Версия: 4
-
- ICS :
- 83.080.01 Plastics in general
Приобрести данный стандарт
Формат | Язык | |
---|---|---|
std 1 92 | PDF + ePub | |
std 2 92 | Бумажный |
- CHF92
Жизненный цикл
-
Ранее
ОтозваноISO 2818:1994
ОтозваноISO 2818:1994/Cor 1:2007
-
Сейчас
-
00
Предварительная стадия
-
10
Стадия, связанная с внесением предложения
-
20
Подготовительная стадия
-
30
Стадия, связанная с подготовкой проекта комитета
-
40
Стадия, связанная с рассмотрением проекта международного стандарта
-
50
Стадия, на которой осуществляется принятие стандарта
-
60
Стадия, на которой осуществляется публикация
-
90
Стадия пересмотра
-
95
Стадия, на которой осуществляется отмена стандарта
-
00
Появились вопросы?
Ознакомьтесь с FAQ
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)