Текущий статус : Отозвано

Это стандарт пересмотренISO 18595:2021

Тезис

ISO 18595:2007 specifies requirements for resistance spot welding in the fabrication of assemblies of aluminium sheet, extrusions (both work- and age-hardening alloys) and/or cast material comprising two or three thicknesses of metal, where the maximum single (sheet) thickness of components to be welded is within the range 0,6 mm to 6 mm.

ISO 18595:2007 is applicable to the welding of sheets or plates of dissimilar thickness where the thickness ratio is less than or equal to 3:1. It applies to the welding of three thicknesses where the total thickness is less than or equal to 9 mm.

Welding with the following types of machines is within the scope of ISO 18595:2007: pedestal welding machines; gun welders; automatic welding equipment where the components are fed by robots or automatic feeding equipment; multi-welders; robotic welders.

The welding of coated material, e. g. zinc coated or anodised material, is not within the scope of ISO 18595:2007.

Общая информация

  • Текущий статус
     : Отозвано
    Дата публикации
     : 2007-09
    Этап
    : Отмена международного стандарта [95.99]
  • Версия
     : 1
  • Технический комитет :
    ISO/TC 44/SC 6
    ICS :
    25.160.10 
  • RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

  2. Интернет-магазин
  3. Каталог стандартов
  4. ТК
  5. ISO/TC 44/SC 6
  6. ISO 18595:2007