Machine tools — Lathe tool posts — Overall internal height

Machine tools — Lathe centres — Sizes for interchangeability

Acceptance conditions for general purpose parallel lathes — Testing of the accuracy

Acceptance conditions for general purpose parallel lathes — Testing of the accuracy

Test conditions for vertical turning and boring lathes with one or two columns — Testing of the accuracy — Part 0: General introduction

Test conditions for vertical turning and boring lathes with one or two columns — Testing of the accuracy — Part 1: Lathes with a single fixed or movable table

Acceptance conditions for vertical turning and boring lathes with one or two columns and a single fixed or movable table — General introduction and testing of the accuracy

Acceptance conditions for horizontal spindle capstan, turret and single spindle automatic lathes — Testing of the accuracy — Part 1: Machinable bar diameters greater than 25 mm

Acceptance conditions for horizontal spindle capstan, turret and single spindle automatic lathes — Testing of the accuracy — Part 2: Machinable bar diameters 25 mm or less and chuck diameter up to 160 mm

Machine tools — Test conditions for horizontal spindle turret and single spindle automatic lathes — Testing of the accuracy

Acceptance conditions for copying attachments, integral or otherwise, for lathes — Testing of the accuracy

Test conditions for numerically controlled turning machines and turning centres — Part 1: Geometric tests for machines with horizontal workholding spindle(s)