Norme internationale
ISO/TR 10358:2021
Tubes et raccords en matières plastiques pour applications industrielles — Collecte de données sur la résistance chimique combinée
Numéro de référence
ISO/TR 10358:2021
Edition 2
Norme internationale
ISO/TR 10358:2021
Indisponible en français
Publiée (Edition 2, 2021)

ISO/TR 10358:2021

ISO/TR 10358:2021
CHF 216
Convertir les francs suisses (CHF) dans une autre devise


This document collects available data on combined chemical resistance of thermoplastic materials typically used to manufacture piping components for industrial applications, against fluids over a range of temperatures.

The base thermoplastic materials covered by this classification are:

Polyethylene                                                              PE

NOTE 1        The PE considered in this document corresponds to PE-HD, with a minimum density value of 0,935 g/cm3 (e.g.: PE63, PE80, PE100, PE100-RC, PE-RT).

Polypropylene                                                           PP (PP-R and PP-RCT, PP-H, PP-B)

Polyvinyl chloride, unplasticized                          PVC-U

Polyvinyl chloride, chlorinated                             PVC-C

Polybutylene                                                              PB

Acrylonitrile/butadiene/styrene                         ABS

Polyvinylidene fluoride                                          PVDF

NOTE 2        This document considers homopolymer PVDF.

Cross-linked polyethylene                                     PE-X (PE-Xa, PE-Xb, PE-Xc)

Ethylene chloro trifluoro ethylene                       ECTFE

Polyamide, unplasticized                                        PA-U (PA-U11, PA-U12)

NOTE 3        This document focuses on PA-U11 and PA-U12 only, as these long chained PA-U are standardized according to ISO 16486-1; short chained (e.g. PA 66) and plasticized PAs are not used for monolithic plastic piping components.

Polysulfone                                                                PSU

Perfluoralkoxy                                                          PFA

NOTE 4        Temperatures higher than 200°C can be applied after an evaluation with the raw material manufacturer.

Polytetrafluoroethylene                                         PTFE

NOTE 5        Temperatures higher than 200°C can be applied after an evaluation with the raw material manufacturer.



Polyphenylene sulphide                                          PPS

NOTE 6        PPS is new with regards to industrial application and chemical resistance issues; for this reason, manufacturers and end-users are advised to assess the chemical suitability of the material.

Informations générales

Vous avez une question?

Consulter notre FAQ

Service à la clientèle
+41 22 749 08 88

Horaires d’ouverture:
De lundi à vendredi - 09:00-12:00, 14:00-17:00 (UTC+1)